Products

Categories

Physics

Linear Air Track Kit

Linear Air Track Kit

Suitable for study of linear motion under nearly frictionless conditions. The kit consists of square section aluminium track, length 1.5m, with two rows of fine holes along the top. Supported on two light alloy castings. One support has a two point contact and other a one point contact for lateral and orizontal adjustments by means of a knurled screw. One end of the section is fitted with a tube for connection to blower and the other end is closed.

Comes complete with following accessories:

?2 heavy and 1 light vehicle with their mass ratio 2:1.
?2 Magnetic buffers
?2 Plasticine Holders with central hole
?4 Catapults with slots for elastic band
?1 Reel of nylon thread
?2 White rods(4 mm diam.150 mm long)
?24 Needles
?20 Black plain cards
?1 Pack of plasticine
?20 Elastic bands
?1 Instruction manual
Linear Expansion Apparatus

Linear Expansion Apparatus

For study of principle of expansion of various metals by heating. Consist of two uprights linked by two rods, supporting an expansion bar, length 38cm, fixed to the upright and resting on a friction pointer placed at the other end. With reading 0 to 90?. With one each aluminium, steel and brass expansion bars.
Oersted?s Law Apparatus

Oersted?s Law Apparatus

To show the action of a current upon a magnet. Comprising of a magnetic needle 75mm long pivoted at the centre of a heavy gauge copper rod rectangle, with terminals.
Organ Pipe

Organ Pipe

This wooden organ pipe is used to study relationship between the frequency of the sound produced with the length of the air column. Consists of a sliding rod with chromatic scale. When fully extended the organ pipe is 70cm long.
PNP Transistor

PNP Transistor

Po Box

Po Box

Portable Wheatstone Bridge

Portable Wheatstone Bridge

Potentiometer

Potentiometer

Consisting of a wooden base with 1m high resistance wire connected to plated brass plates. The plates are fitted with 4mm socket terminals. Wooden scale graduated 0- 100cmx1mm. Complete with knife edge jockey.
Power Supply, Continuously Variable

Power Supply, Continuously Variable

A continuously variable power supply, designed to meet low voltage requirements for the educational laboratories. Output voltage and current are varied by the use of rotary switches. The unit is equipped with front panel meters for reading voltage and current.

Input Voltage - 220V A.C. 50/60Hz

Output Voltage -
0-30V D.C. @ 10A
0-30V A.C.

Any other range can also be provided.

Power Supply, Low Voltage

Power Supply, Low Voltage

A low cost good quality power supply unit with 6 voltage steps from 2V to 12V A.C. & D.C. The voltage is selected through independent sockets. Two separate sockets are provided for 6.3V A.C. Provided with overload protection.
Input Voltage - 220V A.C. 50/60Hz
Output Voltage - 2, 4, 6, 8, 10, 12V A.C. or full wave rectified
D.C. @ 4A
Any other range can also be provided.
Precision Linear Expansion Apparatus

Precision Linear Expansion Apparatus

Elongation of rod is measured by a dial indicator sensitive to 0.01mm. This apparatus is 10 times more accurate than other similar units. Includes one each aluminium, steel and brass bars.
Precision Vernier Potentiometer

Precision Vernier Potentiometer

Primary and Secondary Coils

Primary and Secondary Coils

Consisting of a primary inner coil of insulated copper wire wound upon a cylinder with terminals and a secondary coil wound upon a cylinder into which the primary coil fits. A soft iron core fits the primary cylinder. Complete with 4mm socket terminals.
Proof Plane

Proof Plane

Consist of a brass disc 25mm diameter mounted coaxially on an ebonite rod.
Proof Sphere

Proof Sphere

Consist of a brass sphere 25mm diameter mounted coaxially on an ebonite rod.
Radiation Kit

Radiation Kit

Enables students to investigate the nature of heat radiation and the radiating properties of different surfaces. The kit comprises:
» One radiant heater mounted on a base with mains lead
» One metal plate approximately 150mm square with handle
» One heat shield 220mm square with a 25mm diameter hole in the center
» One glass sheet 220mm square
» One book of aluminium leaf
» One pack of lampblack
Ray Box and Optical Set

Ray Box and Optical Set

A set of optical accessories for performing various experiments in reflection, refraction and colour. The key element is a ray box which has a metal lamp housing 155x70x55mm having an open front with finned sides to dissipate heat. It has four apertures one to accommodate the slit plate and another three for mounting colour filters. The two side apertures are fitted with hinged plane mirrors. With metal plate having single and triple slits and whitened on one side for use as returned image screen, 12V lamp and a lamp holder.

Optical Accessories
» 5 Prisms(Rectangular, semi-circular, triangular 60°x60°x60°, triangular 90°x60°x30°, triangular 90°x45°x45°)
» 3 Cylindrical lenses (one double concave, one double convex, one thick double convex)
» 3 Mirrors (curved parabolic, curved semicircular, mirror on stand)
» 2 Slit plates
» 8 Colour filters
» 6 Colour cards

Set comes complete with a replacement bulb but without power supply.

-01 Complete Set
-02 Raybox only
-03 Power Supply
-04 Replacement Lamp
Rehostate

Rehostate

Resistance Box, Decade Type

Resistance Box, Decade Type

Enclosed in an an aluminium case, this unit has coils of double silk covered manganin wire, wound non-inductively so the box is suitable for both A.C. And D.C. use. Provided with two 4mm socket terminals for connections. Accuracy ±0.1%.
No. of Dials Steps ohms Total ohms

-01 One 0.1 1
-02 One 1 10
-03 One 10 100
-04 One 100 1000
-05 One 1000 10000
-06 Two 0.1,1 11
-07 Two 1,10 110
-08 Two 10,100 1100
-09 Two 100,1000 11000
-10 Three 0.1,1,10 111
-11 Three 1,10,100 1110
-12 Three 10,100,1000 11100
-13 Four 0.1,1,10,100 1111
-14 Four 1,10,100,1000 11110
Resistance Box, Decade Type

Resistance Box, Decade Type

Same as RE5057, but enclosed in a wooden box with a bakelite top.
Resistance Box, Plug Type

Resistance Box, Plug Type

Split brass contact blocks hold precision cut, interchangeable plugs having moulded black bakelite tops, in polished wooden box with bakelite top. Coils of double silk covered manganin wire and provided with two 4mm socket terminals.
Accuracy ±0.1%.

-01 Range 0.1-1 ohm
-02 Range 0.1-5 ohm
-03 Range 0.1-10 ohm
-04 Range 0.1-50 ohm
-05 Range 1-50 ohm
-06 Range 1-100 ohm
-07 Range 1-500 ohm
-08 Range 1-1000 ohm
-09 Range 1-5000 ohm
-10 Range 1-10000 ohm
Resistance Substitution Box

Resistance Substitution Box

A 12 position rotary switch selects values, 33?, 100?, 330?, 1k?, 3.3k?, 10k?, 33k?, 100k?, 330k?, 1M?, 3.3M?, 10M?. Any other range can also be provided.
Resistance Unit

Resistance Unit

In bakelite case with 4mm socket terminals, non-inductively wound coil. Accuracy 1%.

-01 Resistance 0.2 ohms
-02 Resistance 0.5 ohms
-03 Resistance 1 ohms
-04 Resistance 2 ohms
-05 Resistance 5 ohms
-06 Resistance 10 ohms
-07 Resistance 20 ohms
-08 Resistance 50 ohms
-09 Resistance 100 ohms
-10 Resistance 200 ohms
-11 Resistance 500 ohms
-12 Resistance 1000 ohms
Resistors, Mounted

Resistors, Mounted

Consist of seven carbon resistance of values 1ohm, 4.7ohm, 10ohm, 100ohm, 1000ohm, 10kohm, 100kohm mounted on an acrylic board. Each resistor is provided with a pair of 4mm socket connections.
Any other range can also be provided.
Resonance Apparatus

Resonance Apparatus

For easy measurement of velocity sound waves produced by tuning forks. Comprises of a glass tube 100cm long mounted on a stand which is fitted with levelling screws. The lower end of the tube is connected to a water reservoir by rubber tubing. The reservoir slides on a metal rod and can be lowered or raised for adjusting the length of air column.
Resonance Tube

Resonance Tube

Comprising two aluminium tubes telescoping into each other so that the column of air within the tube may be altered from 30cm to 53cm. Outer tube fits on a wooden base.
Rheostat, Closed Type

Rheostat, Closed Type

Same as above, but mounted on metal frame with perforated cover.
Ripple Tank

Ripple Tank

Useful for demonstration of wave patterns. Consists of a metal tray with a plate glass base and detachable legs. A pair of support rods with clamps is provided to carry the wave generation system. A set of 4 metal reflectors is supplied consisting of a pair of straight reflectors 150x25mm, a curved reflector of 215mm chord length x 25mm high and a short straight reflector 25x25mm. A set of 4 loose gauze strips is provided to reduce unwanted reflections. The ripples are produced by a small 1.5V to 4.5V D.C. electric motor mounted at the centre with a row of holes to mount the spherical dipper for the production of circular ripples. Complete with accessories.
Savart?s Toothed Wheels

Savart?s Toothed Wheels

Set of four wheels of 75mm diameter, mounted on a spindle. Ratio of teeth being 4:5:6:8. For use with Whirling Table
Senior Kelvin Double Bridge

Senior Kelvin Double Bridge

Smoke Cell

Smoke Cell

Solenoid

Solenoid

To study the magnetic field linked with a solenoid coil. Consists of a copper wire coil 10cm long x 50cm diameter wound on an acrylic sheet, with 4mm socket terminals.
Solenoid, Magnetising & Demagnetising

Solenoid, Magnetising & Demagnetising

For magnetising and demagnetising steel rods, strips etc. Comprising a solenoid 15cm long x 2.5cm diameter mounted on a wooden base, with 4mm socket connections.
Sonometer, 3-Wire Type

Sonometer, 3-Wire Type

A hollow wooden resonance box, with 100cm scale graduated in mm and fitted with three wires and keys. A pulley is attached to one end of the box. Complete with sliding adjustable.
Sonometer, Spring Type

Sonometer, Spring Type

A wooden baseboard 70x9cm mounted on four feet. At one end of the base are two 50N spring balances with hooks, and at the other end are two corresponding wrest-pins. Three bridges, one large and two small are provided. With two steel wires 0.3mm diameter x 1m.
Standard Resistance

Standard Resistance

standard resistance

standard resistance

Steam Generator

Steam Generator

Copper body and conical top. Fitted with inlet and outlet tubes and water gauge.
Tangent Galvanometer

Tangent Galvanometer

Magnetometer supported on brass tube fitted on bakelite plate free to revolve in the base of the instrument. Magnetometer and bakelite ring both can rotate independently of the base, fitted with levelling screws. Compass box consists of a bakelite case with metal dial graduated in degrees and anti-parallax mirror. Cobalt steel magnet and aluminium pointer mounted on special synthetic saphire, needle moves on hardened steel pivot. Ring dia 162mm. Winding 2, 50, 500 turns.
Voltmeter

Voltmeter

Voltmeter D.C.
Moving coil meters. Scale length 60mm approx. with knife edge pointer and anti parallax mirror scale. Size 80x110x80mm. Accuracy ?2% F.S.D.

Single Range
-01Microammeter, 0-25?A
-02Millivoltmeter, 0-25mV
-03Millivoltmeter, 0-1000mV
-04Voltmeter, 0-1V
-05Voltmeter, 0-3V
-06Voltmeter, 0-5V
-07Voltmeter, 0-10V
-08Voltmeter, 0-100V
-09Voltmeter, 0-300V
Double Range
-10Voltmeter, 0-5V and 0-15V
Triple Range
-11Voltmeter, 0-3V, 0-10V and 0-15V
-12Voltmeter, 0-3V, 0-15V and 0-300V
Rectifier type.
-13Voltmeter, 0-5V
-14Voltmeter, 0-10V
-15Voltmeter, 0-50V
-16Voltmeter, 0-100V
Water Bath

Water Bath

Wheatstone Bridge

Wheatstone Bridge

With 4 gaps, nickel plated brass plates and connecting pieces, with 4mm socket terminals, fitted on wooden base. Wooden scale graduated 0-100cmx1mm. Complete with knife edge jockey.
Wheatstone Bridge, Dial Type

Wheatstone Bridge, Dial Type

Consists of four dials in series of ranges X1, X10, X100, X1000 having total resistance 11110 ohms. Two ratio dials having resistance of 1, 10, 100, 1000 are provided. Terminals for connecting galvanometer and battery with press keys are also provided. The unknown resistance is connected between two terminals marked ?X?. The instrument can also be used as four dial decade resistance box and two terminals for connecting it in series are also provided.
Whirling Table

Whirling Table

For use in both vertical or horizontal position, fitted with hand wheel and belt driven pulley, with adapter for clamping accessories. Over all height 43cm.